Filter
Top Products
96 System Setup
Remote
Wakeup
(Off
default)
This option allows the system to power up when a Network
Interface Controller (NIC) or Remote Wakeup-capable modem
receives a wake up signal.
On
is the default setting.
On w/ Boot to NIC
will allow the
computer to attempt to boot from a network prior to using the
boot sequence.
NOTE: Normally, the system can be powered up remotely from
suspend mode, hibernate mode, or when powered off. When
Low Power Mode (in the Power Management menu) is enabled,
the system can only be powered up remotely from Suspend.
Suspend Mode Sets the computer’s suspend mode. The options are S1, a
suspend state in which the computer is running in a low-
power mode, and S3, a suspend state in which the power is
reduced or turned off for many components, however, system
memory remains active.
Maintenance
Service Tag Displays the service tag for your computer.
ASF Mode Controls ASF management.
• On = Full ASF 2.0 functionality (RMCP)
• Alert Only - send ASF messages on event or error
• Off - all ASF functionality disabled
SERR Message
(On default)
Some graphics cards require that the SERR message be
disabled.
Load
Defaults
Restores system setup options to their factory defaults.
Event Log Allows you to view the Event Log. Entries are marked R for
Read and U for Unread. Mark All Entries Read puts an R to
the left of all the entries. Clear Log clears the Event Log.
POST Behavior