Filter
Top Products
120 Adding and Replacing Parts
To replace the hard drive:
1
Follow the procedures in "Before You Begin" on page 117.
2
Turn the computer over, and remove the hard drive screws.
NOTICE: When the hard drive is not in the computer, store it in protective antistatic packaging. See "Protecting
Against Electrostatic Discharge" in the Product Information Guide.
3
Slide the hard drive out of the computer.
4
Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the
connector.
5
Slide the hard drive into the bay until it is fully seated.
6
Replace and tighten the screws.
7
If the new hard drive is not already pre-imaged, install the operating system and drivers for your
computer.
See
"Restoring Your Operating System" on page 113 and "Reinstalling Drivers and Utilities"
on page 111.
1 hard drive screws (2) 2 hard drive
2
1