Filter
Top Products
122 Appendix
These limits are designed to provide reasonable protection against harmful interference in a residential
installation. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference with radio or television reception, which can be
determined by turning the equipment off and on, you are encouraged to try to correct the interference by
one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the system with respect to the receiver.
• Move the system away from the receiver.
• Plug the system into a different outlet so that the system and the receiver are on different branch
circuits.
If necessary, consult a representative of Dell Inc. or an experienced radio/television technician for
additional suggestions.
The following information is provided on the device or devices covered in this document in compliance
with the FCC regulations:
NOTE: For Further regulatory information, see your Product Information Guide.
Contacting Dell
You can contact Dell through the Internet and by phone:
• For support through the web, go to
support.dell.com
.
• For worldwide support through the web, use the
Choose A Country/Region
menu near the bottom of
the page, or see the web addresses listed in the following table.
• For support by e-mail, see the e-mail addresses listed in the following table.
NOTE: Toll-free numbers are for use within the country for which they are listed.
• For support by phone, use the phone numbers and codes provided in the following table. If you need
assistance in determining which codes to use, contact a local or an international operator.
NOTE: The contact information provided was deemed correct at the time that this document went to print and is
subject to change.
Product name:
Dell™ Dimension™ E521
Model number:
DCSM
Company name: Dell Inc.
Worldwide Regulatory Compliance & Environmental
Affairs
One Dell Way
Round Rock, TX 78682 USA
512-338-4400
book.book Page 122 Monday, July 23, 2007 3:47 PM