Filter
Top Products
Installing System Components 45
Figure 3-5. Removing or Installing a Diskette Drive
7
If you are permanently removing the drive, replace the 3.5-inch insert on front drive bezel. See
"Replacing an Insert on the Front Drive Bezel" on page 44.
If you are replacing the diskette drive, see "Installing a Diskette Drive" on page 45.
8
Replace the front drive bezel. See "Replacing the Front Drive Bezel" on page 43.
9
Close the system. See "Closing the System" on page 41.
10
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Installing a Diskette Drive
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 41.
1 arrow on the sliding plate 2 sliding plate 3 drive-stop tab
4 power cable to diskette
drive (P7)
5 data cable to diskette drive 6 data cable to system board
connector (FLOPPY)
5
6
2
3
1
4
book.book Page 45 Tuesday, August 25, 2009 1:14 PM