Filter
Top Products
Installing System Components 65
Replacing the Processor
1
U
npack the new processor
.
2
Ensure that the contacts on the bottom of the replacement processor are free from dirt or other foreign
material.
3
Align the notched edge of the replacement processor with the tab on the processor frame. See
Figure 3-16.
NOTICE: Use caution when removing and installing the processor. Damaging the processor socket connectors
can damage the system board.
4
Carefully set the processor in the processor frame. Ensure that the notched edge of the processor fits
securely over the matching tab on the processor frame. Do not press down on the processor. If the
processor is seated correctly, it should fit snugly in the socket frame. See Figure 3-16.
5
Lower the retention latch onto the processor, and then rotate the release lever back toward the system
board until it snaps into place.
6
Clean the thermal grease from the bottom of the heat sink.
NOTICE: Ensure that you apply new thermal grease. Applying new thermal grease is critical to ensuring proper
thermal bonding as well as optimal processor operation.
7
Apply new thermal grease to the top of the processor.
8
Place the heat sink assembly back onto the heat sink assembly bracket and tilt the heat sink assembly
down on the system board. See Figure 3-15.
9
Align the two captive screws properly with the system board, then tighten them to secure the heat sink
assembly to the system board.
10
Close the system. See "Closing the System" on page 41.
11
Reconnect the system to the electrical outlet, and turn on the system and attached peripherals.
Cooling Fans
The system contains two cooling fans, one for the processor and one for the card cage. Each contains a
shroud that is part of the cooling fan assembly. The fan and shroud are replaced as a unit.
NOTE: If you are removing the larger processor cooling fan, you must first remove the heat sink and shroud
assembly. See "Removing the Processor" on page 62 (however, do not remove the processor) and Figure 3-17.
Removing the Cooling Fans
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
1
Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 41.
book.book Page 65 Tuesday, August 25, 2009 1:14 PM