Filter
Top Products
2007-07-09
5011659301-SBT
1
CME-USB01 USB Interface for VFD-E Series Instruction Sheet
Please thoroughly read this instruction sheet before installing option cards and putting them into
use.
The content of this instruction sheet may be revised without prior notice. Please consult our
distributors or download the most updated version at http://www.delta.com.tw/industrialautomation/.
X Layout
USB Card (CME-USB01)
Y
Installation
Make sure that the AC Motor Drive is powered
off before operation. DO NOT insert or remove
the card when the AC Motor Drive is powered
on.
Please mount the extension card as shown and
fix it with the screw packed with the card.
Screw torque:
Maximum 2kgf-cm
USB Cable
USB Type B to CME-USB01
USB Type A to PC
NOTE
Refer to Chapter 5: Parameters 9 (Group 9) in
the user manual for further details.
Z Specification
Environmental
Operating
Temperature
-10
o
C to 50
o
C (non-condensing
and not frozen)
Storage
Temperature
-20
o
C to + 60
o
C
Ambient
Humidity
Less than 90%RH
(non-condensing)
Installation
Altitude
Below 1000m
Vibration
Less than 20Hz:
Maximum 9.81 m/s
2
(1G);
20 ~ 50Hz:
Maximum 5.88 m/s
2
(0.6G)
NOTE
Always use this product in a clean indoor
location free from dust, corrosive gas and liquid.
Inputs/Outputs
Baud Rate
Supports 4800, 9600, 19200,
38400, 57600 bps.
USB
Specification
USB v1.1
[
Notes
Please use shielded wires to avoid interferences
and connect the shield to ground.
To avoid interference, route the extension card
wires separately and as far away (at least 15cm)
as possible from other control wires, motor wires
and power wires, etc. Where these wires must
cross each other, please make sure they are at
a 90
o
angle.
Always use and operate this product within the
limit of its specifications.