Filter
Top Products
152
7 Configuration Command Reference
7.8 DTC Configuration Commands
The DTC configuration commands are:
• DTC_CONFIG - Configure DTC
• DTC_SSR - DTC Sub System Resource
7.8.1 DTC_CONFIG – Configure DTC
Synopsis
The DTC_CONFIG command supplies the global configuration parameters for the DTC protocol, activating
DTC and higher protocols.
Syntax
DTC_CONFIG <num_servers> <server_selection> <host_number> <rsi_status_user_id>
Example
DTC_CONFIG 2 0 0 0xef
Parameters
The DTC_CONFIG command includes the following parameters:
• <num_servers>
Number of servers in the system.
• <server_selection>
The selection mechanism used by DTC to select which server to be used. See the DTC User Guide.
• <host_number>
The host number, which should be unique across hosts.
• <rsi_status_user_id>
Module ID to forward RSI link status messages to.
7.8.2 DTC_SSR – DTC Sub System Resource
Synopsis
The DTC_SSR command configures a local subsystem using DTC. The command works in a similar way to the
SCCP_SSR LSS command but configures the subsystem to run on top of DTC instead of SCCP. DTC and SCCP
cannot be used at the same time, so the SCCP_SSR and DTC_SSR commands are incompatible with each
other.
Syntax
DTC_SSR <ssr_id> LSS <local_ssn> <module_id> <reserved> <protocol>
Example
DTC_SSR 1 LSS 0x07 0x0d 0 TCAP
Parameters
The DTC_SSR command includes the following parameters:
• <ssr_id>
A unique ID for the SSR.
• <local_ssn>
The local sub-system number as defined by the SCCP protocol.
• <module_id>
The module identifier of the user application on the host computer that implements the local sub-system.
• <reserved>
Must be set to 0.