Filter
Top Products
IMG 1010 - SD Card
81
4. Any line beginning with the # symbol is a comment and is not processed by the IMG.
Below is the information the user will edit for use in their network
yiaddr --> IP Address of the IMG being loaded
subnetmask --> Subnet mask of the IMG being loaded
giaddr --> IP Address of the Gateway connected to the IMG
file --> If using the SD card to supply boot information but loading the
software from the FTP Server; the System Software Filename on the
bootup.cfg file should be given a path to the IMG System Software file located
on the ftp server. The default path is /excelsw/ftpBuilds or ftpBuilds/ as the
IMG 1010 logs into the FTP server using the excelsw account.
Host flag --> The Host Flag informs the IMG 1010 of configuration details
such as T1 or E1, Boot from SD card or Boot from FTP Server, and a few other
configuration details. See Setting Host Flags.
siaddr --> IP Address of FTP server which provides the IMG 1010 System
Software and NTP Server information
sname --> Optional, not currently used. Do not edit this.
5. Change the Host Flag to "Retrieve IMG Build from SD Card".
Host Flag Values
32 = Boot from SD Card, T1 system
34 = Boot from SD Card, E1 system
Example: The following is a T1 system booting from SD Card. Refer to the file Setting
Host Flags to follow the example
Boot From SD card = 32
T1 system = add +00
Host Flag Value = 32
The Host Flag for a T1 system booting from SD Card = 32
6. Edit the bootup.cfg file to reflect the new Host Flag value
7. Edit the System Software Filename in the bootup.cfg file to reflect the new software file
being loaded. (Ex: file=/excelsw/ftpBuilds)
8. Edit the rest of the bootup.cfg file to reflect your network values.
9. Save the bootup.cfg file.
10. Remove the SD card from the SD Writer.
11. Insert the SD card into the SD slot on the Front Panel of the IMG.
12. Power-up the IMG. The fans on the IMG will run at full speed while diagnostics are
running and software is being loaded
13. The LCD screen will show the following:
While software is loading to the IMG 1010 the LCD screen will display the following
MAC: 00:20:1C:04:03:11 ID:0101
SDC Loading
After the software has loaded to the IMG 1010 the LCD screen will display the following
MAC: 00:20:1C:04:03:11 ID:0101
Load OK/Jumping to Load
After software is done loading, the LCD screen will display the node info and the fans will
slow to normal operation
Node Name: IMG1010
Node ID: 255
14. The loading of software and configuring of network information is now complete. The IMG
1010 is now ready to be configured.