Filter
Top Products
USB Plus Series Installation Guide (90000410 Rev. C) – Page 14
Regulatory & Other Information
© 2006 Digi, Digi International, the Digi logo,
the Digi Connectware logo, Inside Out Networks
and its logo, Edgeport, and Hubport are either
trademarks or registered trademarks of Digi
International, Inc. in the United States and/or
other countries. All other trademarks are the
property of their respective holders.
Information in this documentation is subject to
change without notice and does not represent a
commitment on the part of Digi International.
Digi International provides this document “as
is,” without warranty of any kind, either
expressed or implied, including, but not limited
to, the particular purpose. Digi International may
make improvements and/or changes to this
documentation or to the product(s) and/or
program(s) described in this documentation at
any time.
Digi International assumes no responsibility of
any errors, technical inaccuracies, or
typographical errors that may appear in this
documentation, nor liability for any damages
arising out of its use. Changes are made
periodically to the information herein; these
changes may be incorporated in new editions of
the publication.
For U.S. Government use:
Any provision of this document and associated
computer programs to the U.S. Government is
with “Restricted Rights.” Use, duplication, or
disclosure by the government is subject to the
restrictions set forth in, subparagraph (c) (1) (ii)
of the Rights in Technical Data and Computer
Software clause of DFARS 52.277-7013.
For non-U.S. Government use:
These programs are supplied under a license.
They may be used, disclosed, and/or copied only
as supplied under such license agreement. Any
copy must contain the above copyright notice
and restricted rights notice. Use, copying, and/or
disclosure of the programs is strictly prohibited
unless otherwise provided for in the license
agreement.
Federal Communications Commission
(FCC) Regulatory Information (USA only)
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment
generates, uses, and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on,
the user is encouraged to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and the receiver.
• Connect the equipment into an outlet that is
on a circuit different from the receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Warning: The connection of a non-shielded
interface cable to this equipment will invalidate
the FCC Certification for this device.
FCC Regulation - Part 15
Declaration of Conformity (DoC)
This device complies with the requirements of
the Code of Federal Regulations listed below:
FCC Title 47 CFR, Part 15 Class B for a digital
device.
Operation is subject to the following two
conditions:
This device may not cause harmful interference,
and
This device must accept any interference
received, including interference that may cause
undesired operation.
Department of Communication (DOC)
Notice (Canada only)
This Class B digital apparatus meets the
requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la Classe B respecte
toutes les exigences du Règlement sur le matériel
brouiller du Canada.