Filter
Top Products
Chapter 4: Web Configuration
87
The WAN IP settings page will differ
slightly according to the protocol that
you choose. This graphic is the one
that you will see if you choose the
PPPoE mode in the previous step.
You can select Enable NAT or PPP IP
extension according to your needs.
And you can also change the MTU
value.
Add Default Route:
Check this item to add a default route.
The next figure following the WAN IP
Settings under the PPPoE mode is
shown at the right. You may refer to
the Quick Setup for further
information.
If you choose IP over ATM from the
Connection Type web page, you will
get a web page as the figure.
You may refer to Quick Start-
Connection Type- IPoA section for
more information.
Add Default Route:
Check this item to add a default IPoA
route onto the routing table.
If you choose Bridging from the
Connection Type web page, you will
get a web page as the figure listed at
the right side.
Please refer to Quick Setup for more
information.