Filter
Top Products
Chapter 4: Web Configuration
89
Internet – ADSL
Enable ADSL Port:
Check this box to enable this function.
It simply invokes the line mode that
you choose here for the router.
Select the support of line modes:
There are several selections, and you
may select them according to the line
modes supported by your ISP and
your needs.
Capability Enabled:
Two items are provided here for you to
choose.
Bitswap:
It is a mandatory receiver initiated
feature to maintain the operating
conditions of the modem during
changing environment conditions. It
reallocates the data bits and power
among the allowed carriers without
modification of the higher layer control
parameters in the ATU. After a bit
swapping reconfiguration, the total
data rate and the data rate on each
latency path is unchanged. Check this
box to enable the function. If not,
uncheck this box to close the function.
Seamless Rate Adaptation:
It enables the ADSL2/
A
DSL2+ Router
to change the data rate of the
connection while in operation without
any service interruption or bit errors.
Check this box to enable the function.
If not, uncheck this box to close the
function.
IP Routing – Static Route
The table shows all static route status and allows you to add new static IP route or
delete static route. A Static IP Routing is a manually defined path, which determines
the data transmitting route. If your local network is composed of multiple subnets,
you may want to specify a routing path to the routing table.
Destination Network Address:
Display the IP address that the data
packets are to be sent.
Netmask, Gateway, WAN Interface:
Display the subnet mask, gateway,
and WAN interface information that
the transmitting data will pass through.
Delete:
Allow you to remove the static route
settings.
This page shows all the routing
table of data packets going
through your ADSL Router.
Adding a New One
To add a static route, please click Add. Type the destination network address,
subnet mask and gateway that you received from the ISP and click Apply.