Filter
Top Products
3 Installation of the Switch
9
3 Installation of the Switch
Quick Installation
ECOM-ES24F2G Fast Ethernet Switch is fully compliant with 10/100BASE-TX Fast Ethernet
standards.
5 Steps to Quick Installation
Step 1. Power on the Switch.
Step 2. Connect network devices to the Switch: connect either workstation, server, switch, bridge
or router to the station port (10/100BASE-TX), using 100 ohm unshielded twisted pair (category 5
UTP) or shielded twisted-pair (STP) cable.
Step 3. Install the Management software: Please refer to chapter 5 for detail instruction on how to
install and configure the management software.
Rack Mounting
ECOM-ES24F2G Fast Ethernet Switch can also be mounted on a standard size 19-inch rack, which
can in turn be placed in a wiring closet with other equipments.
Before you can mount the switch on the rack, first you must attach the mounting brackets on both
sides of the switch with screws, and then mount it as a unit on the rack.
To mount the unit on a rack, please follow the steps below:
Step 1. First, align the holes on the bracket with the holes on both side of the switch.
Step 2. Insert screws into the holes and then fasten the bracket on one side of the switch with a
screwdriver.
Step 3. Repeat Step 1 and 2 to fasten the bracket on the other side of the switch.
Step 4. Mount the unit on the rack and align the notches on both brackets with mounting holes
on the rack, and then secure the unit with suitable screws.
ECOM ES24F2G the Gigabit Ethernet Switch User’s Manual V1.0