Filter
Top Products
26
■
Installing the UM-1 driver
Use either OMS or FreeMIDI as the MIDI driver.
The included
UM-1 driver
is an add-on module for using the UM-1EX with OMS or FreeMIDI.
OMS can be found in the
OMS 2.3.8 E
folder within the
OMS (Mac OS 9)
folder of the CD-ROM.
If you would like to know more about OMS, refer to
OMS_2.3_Mac.pdf
which can be found in the
same folder.
* Either
OMS
or
FreeMIDI
must be installed in your Macintosh, as appropriate for the sequencer software
you are using.
* If you install OMS after installing the UM-1 driver, you must install the UM-1 driver once again.
1.
With the UM-1EX left unconnected, start up Macintosh
* Disconnect all USB cables other than those for your keyboard and mouse, and restart your Macintosh.
2.
Exit all currently running software (applications).
3.
Prepare the CD-ROM. Insert the CD-ROM into the CD-ROM drive of your Macintosh.
4.
Double-click the
UM-1 Driver-E Installer
icon (found in the
Driver E (Mac OS 9)
folder of the CD-
ROM) to start up the installer.
Mac OS 9 users
If a UM-1EX is already connected to your Macintosh when you install the driver, a message like
the following will appear when the Macintosh is started up. Perform the steps described below as
appropriate for the message that is displayed.
If the screen indicates:
“Software needed for the USB device “UM-1” is not available. Would you like to look for
the software on the Internet?”➔ click [Cancel].
UM-1EX_multi1.book 26 ページ ２００５年１１月１日 火曜日 午後３時１９分