Filter
Top Products
Additional Tractor Unit
Using two tractor units in combination
1.
Install one tractor unit in the pull-tractor position as described
in Chapter 2. Install another one in the front or rear position.
2.
Place the continuous paper on the sprocket units of the front
or rear push-tractor unit (see Using Continuous Paper in
Chapter 2).
3.
Turn on the printer. Press the LOAD/EJECT button to load paper;
then hold down the LF/FF button to feed one page of paper.
CAUTION: Use the knob on the left side of the printer
only to clear paper jams when the printer is off.
Otherwise you may damage the printer or lose the top-
of-form position.
4.
5.
6.
Release the sprocket lock levers of the pull tractor and adjust
the sprocket units to match the width of the paper. Be sure
that the sprocket units on both the tractors are aligned so that
the paper is not crooked.
Fit the holes of the paper over the tractor pins of the sprocket
units and adjust the sprocket units as necessary (see Using
Continuous Paper in Chapter 2).
Close the sprocket covers.
4-14
Using the Printer Options