Filter
Top Products
Installing the Drivers
To install the drivers, follow the steps below:
1.
If you have not installed OS/2 1.1, follow the instructions in
your OS/2 manual to install it. Configure OS/2 for a
standard VGA driver.
2.
Reset the computer and verify that OS/2 and Presentation
Manager are operating properly.
3. If you are running Presentation Manager, exit from it.
4.
Run the VGA Driver Setup program on your Utility 1
diskette to copy the appropriate Presentation Manager
drivers to your hard disk. See “Using the VGA Driver Setup
Program” on page A-4 for instructions.
When Setup asks for the name of the drive and directory to
contain the driver files, enter the following:
5.
Remove the Utility diskette from drive A.
6.
Type C : \VGA and press Enter to log onto the VGA
directory on your hard disk drive.
7.
Type
DIR and press
Enter
to display a list of the driver files
you copied to the VGA directory. If you copied all of the
16-color and 256-color graphics drivers to this directory, you
see all of the files (listed at the beginning of this section in
parentheses beside the resolutions they control).
8.
Copy the desired driver file to the VGA directory using the
filename VGA.DLL. For example, to copy the 1024 x 768,
16-color graphics driver, type the following and press Enter:
COPY
VGA768.DLL VGA.DLL
A-14
Using the VGA Utilities