Epson 780c Projector User Manual


 
1
Locate the required cables:
2
Connect the computer cable to
the blue Computer/Component Video
port on the projector.
3
Connect the other end to your notebook’s video-out
or monitor port.
NOTE: If your notebook has a DVI connector, you need to use an
optional DVI-to-VGA adapter with the included computer cable
(see your computer’s documentation).
4
Connect the power cord to the
projector, then plug the other end
into an electrical outlet.
1
Turn on your notebook.
2
Remove the projector’s lens cover.
3
Make sure the Power light
is orange and not flashing.
4
Press the Power button
to turn on the projector.
S
T
A
R
T
H
E
R
E
Turn on your equipment
Connect the projector
to your notebook
Follow these instructions to connect the projector to your
notebook. For other setup options, see your User’s Guide.
Epson
®
PowerLite
®
750c/760c
Quick Setup
Power cord VGA computer cable
1
If you’ve turned on your notebook and you don’t see an image,
press the Source Search button on the projector to select the
image source.
NOTE: If you still see a blank screen or have other display problems,
see the troubleshooting tips on the back of this sheet.
2
Turn the focus ring to sharpen the image.
Turn the zoom ring to reduce or enlarge the image.
3
If your image looks like or , you’ve placed the projector off
to one side of the screen at an angle. Place it directly in front of the
center of the screen, facing the screen squarely.
4
If your image looks like or , press the or buttons
on the projector to correct it.
Adjust the image
CAUTION: Before unplugging the projector...
Shut down the projector properly:
1. Press the Power button twice.
2. When the orange light stops flashing and the projector beeps,
you can unplug the projector.
Power button
Power light
Zoom
Focus
PL750760_QS_CPD20249.qxd 6/24/05 3:25 PM Page 1