Filter
Top Products
36
6. In the file Server Console’s MONITOR.NLM, select the Connection
Information. Check if the print server name assigned to the Ethernet card has
been logged in to the Active Connections list. It takes up to five minutes to
complete this.
Once you make changes to the Ethernet card, you must wait
until it registers the settings (the “Configuration is
successfully done” message appears) before you turn off the
printer.
Using EPSON Net!2 to Configure the Card in Remote
Printer Mode
If the Status Monitor 2 utility is running, or if background
monitoring is turned on, it may interfere with EPSON Net!2. Close
Status Monitor 2 if it is running and turn off background
monitoring, following step 14 on page 25.
If you have connected more than one printer with the same type
of Ethernet card to the network, you can distinguish the cards by
their MAC addresses. Press and hold the card’s status sheet
button for three seconds to print a status sheet with the MAC
address of the card.
If the IP address is set to the default IP address, the printer model
might not appear.
Follow these steps:
1. From the System Console of the file server where you set the print queue, load the
print server module with the following command (use the print server name
which you assigned in step 4 on page 27):
>Load PSERVER print server name
instconf.fm Page 36 Friday, February 19, 1999 4:00 PM