Filter
Top Products
5.
Insert the blank diskette (the target) into the drive. Press
any key. If the new diskette is not formatted, DISKCOPY
formats it and then copies the contents of memory to the
diskette. When the copy is complete, you see this message:
Copy another diskette (Y/N)?
6.
Press Y and Enter to copy another diskette or N and Enter
to return to the MS-DOS command prompt.
Using DISKCOPY with one drive only
If your computer has only one diskette drive and no hard disk,
follow these steps to copy a diskette:
1.
Make sure the diskette you want to copy is write-protected.
(See “Write-protecting Diskettes” in Chapter 3 for
instructions.)
2.
Insert the Operating 1 diskette in the diskette drive.
3. At the
A>
prompt, type the following and press
Enter:
DISKCOPY A: A:
MS-DOS displays this message:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
4. Remove the Operating 1 diskette and insert the diskette
you want to copy (the source) in the diskette drive and
press any key. DISKCOPY copies the contents of the
diskette to the computer’s memory. Then the screen
displays this message:
Insert TARGET diskette in drive A:
Press any key when ready . . .