Filter
Top Products
Then follow these steps to use the CF command:
1.
To run the program from a diskette, insert the Reference 1
diskette in drive A and log onto drive A. To run the
program from a hard disk, log onto the drive and directory
where you copied the configuration files.
2.
Then type the following and press [Enter] to start the program:
CF [parameters]
The table below describes the parameters you can use to
modify the way the program runs on your computer.
CF command parameters
Parameter
/B
ID
IF
/H
IK
/M
Mode
T
BIOS video mode
Dispatcher
spawning mode
Fast
configuration
operation
High resolution
display mode
Keyboard only
mode
Monochrome
display mode
Non-target
modeling mode
Suppress reboot
mode
-.-
Function
Causes the program to be displayed
using BIOS Int 10h calls for systems using
non-standard displays. In default mode,
the it writes directly to video memory.
Causes the program to be spawned by
the dispatcher.
Causes the program to determine the
boards and options installed and
configure your system automatically.
Displays 43 lines on an EGA monitor and
50 lines on a VGA monitor. In default
mode, the screen displays 25 lines.
Sets the program so a mouse cannot
be used, even if you have installed one.
In default mode, you can use a mouse
as long as a mouse driver is loaded.
-
Causes the program to be displayed in
black and white only. In default mode,
color monitors display in color.
Runs the program in non-target
modeling mode.
Causes the program to exit without
rebooting the computer.
Running System Configuration
2-23