Filter
Top Products
To connect the cable, align the cable connector with the drive
interface so the connector row that has a blocked hole lines
up with the interface row that has a missing pin, as shown
below. Then push in the connector.
missing pin
blocked hole
Note
If you are connecting a non-Epson drive, see the manual
that came with it for instructions on connecting the drive
cable.
4.
Arrange the drive and power cables so you can close the
clasps on the side of the subassembly.
5.
Replace the computer’s front panel and cover as described in
Chapter 4; then follow the “Post-installation Setup
Procedures” on page 4-12 to update your configuration.
6-20 Installing and Removing Drives