Filter
Top Products
Post-installation Setup Procedures
After you install or remove options, you need to run the System
Configuration program on your Reference 1 diskette so you can
update your system’s configuration information. The program
will automatically update the information about some optional
equipment, such as additional memory or a math coprocessor.
See Chapter 2 for instructions.
If you installed a hard disk drive that has never received a
low-level format, you need to format the disk. Check the
manual that came with your drive, and then, if necessary,
follow the instructions in Appendix B to format your new hard
disk.
You may also want to test a newly-installed option. Some
options come with their own diagnostic test programs. You can
test the following options with the System diagnostics program
on your Reference 2 diskette:
Q
System memory
0
Numeric coprocessor
Q
Serial and parallel ports
Ll
Disk drives
Cl
Dot matrix printers.
See Appendix A for instructions.
4-12
Accessing Internal Components