Filter
Top Products
37
Preventing theft (Password Protect)(EMP-9300 only)
If an attempt is made to carry out any of the following user logo
operations, a message is displayed and the setting can not be changed. To
change the setting, set "User’s Logo Protect" to "OFF" first. p.38
• Capturing a user's logo
• Changing the setting for the "No-Signal Msg." command in the "Setting"
menu from "Logo" to "Black", "Blue" or "OFF", or when changing it
from "Black", "Blue" or "OFF" to "Logo"
• Changing the setting for the "A/V Mute" command in the "Setting" menu
from "Logo" to "Black" or "Blue", or when changing it from "Black" or
"Blue" to "Logo""
• Changing the "Startup Screen" setting in the "Advanced" menu ("ON" or
"OFF")
Setting Password Protect
Use the following procedure to set Password Protect.
After the Password Protect setting menu has been displayed, the
subsequent operations are the same as for the configuration menu.
PROCEDURE
Press the [Freeze] button on the remote control for
approximately five seconds.
The Password Protect menu will be displayed.
When "User’s Logo Protect" is enabled (ON)
1
Password Protect
ON OFF
:
:
User's Logo Protect
Timer-el apsed
Set
ON: OFF
0H
0H Timer
Power ON Protect
Set
Password
Remote control
TIP
• If Password Protect has already been enabled, the "Password"
screen will be displayed.
If the password has been entered correctly, the "Password Protect"
menu will be displayed.
See "When Password Protect is enabled" p.36
• If Password Protect is set to "ON", attach the accessory Password
Protect sticker to your preferred position on the projector as a
theft-prevention measure.