Filter
Top Products
49
Adjusting the Screen Image
Focusing the Screen Images (Focus Adjustment)
PROCEDURE
Press the [Focus] buttons on either the remote control or
the projector's control panel.
Adjusting the Image Angle
If the projector is set up so that it is at a horizontal or vertical angle to the
screen, adjust as follows.
• You can use the lens shift function to move the lens vertically in order to
adjust the vertical position of the lens. This can be used at times such as if
the screen is in a high position or the projector is suspended from a high
ceiling. p.50
• If correct adjustment cannot be obtained using the lens shift function,
extend the front adjustable feet to tilt the projector. p.51
When the projector is tilted, keystone distortion may appear in the
projected images. If this happens, you can correct this keystone
distortion. p.52
TIP
• Do not use electronic focus adjustment (using button operations) if
the projector is fitted with an optional rear projection wide lens.
Refer to the documentation for the rear projection wide lens for
further details.
• If the surface of the lens is dirty or misted over as a result of
condensation, it may not be possible to adjust the focus correctly. If
this happens, clean or de-mist the lens. p.123, p.130
Remote control
If the projection area is too low or too high for the screen