Filter
Top Products
When you send more data, the paper automatically feeds back to
the loading position. If you want to change the position where
printing begins on the page, follow the steps on page 2-5 to adjust
the loading position.
Switching back to single sheets
To switch to single sheets, press the FONT and LF/FF buttons at
the same time; the printer feeds the paper backward into the
paper-park position. Then, follow the steps in “Loading single
sheets.”
c
Caution:
Always tear off paper before back-feeding; back-feeding too
many sheets can cause a paper jam.
Printing with the pull tractor
To load continuous paper using the pull tractor, you must move
the tractor to the pull tractor position, as described in steps 1
through 3 below. If your tractor is already installed in this
position, make sure the printer is off and skip to step 6.
c
Caution:
When using the pull tractor, set the Auto tear off feature in the
Printer Setting mode to off; otherwise the paper may jam.
1. Turn the printer off; then remove the paper guide. Pull the
paper-release lever forward to the continuous paper position
as shown in the illustration on page 2-7.
R
Blueberry REV.D
A5 size Chapter 2
95/01/20
Using the Printer
2-11