Filter
Top Products
3 • Adjusting Projector Settings
72
Adjusting Video Settings (Image Source = Computer)
You can adjust the projected image by using the Video menu. The
following options are available when the image source is Computer.
Note:
The computer must be connected and operating, and the
image source on the projector must be set to Computer for you to
access these menu options. To change the image source on the
projector, press the Source button on the remote control or control
panel.
Menu item Description
Position Select this item by pressing the Enter
button (control panel) or the
top or bottom multi-purpose button (remote) to enter screen position
(H/V) adjustment mode. Then use the pointer button (remote) or up,
down, left, and right buttons (control panel) to move the screen position
in the corresponding direction.
When you finish making adjustments, press the Menu button on the
control panel or the remote to return to the Video menu.
Tracking Matches the projector’s internal clock to various computer graphic
signals. Adjust this setting to remove vertical lines from the image.
Sync. Synchronizes with the tracking signal sent from the computer. Adjust
this setting to correct fuzziness or screen flicker.
Brightness Lightens or darkens the overall image. Increase brightness to lighten an
image, or decrease it to darken the image.
Contrast Adjusts the difference between light and dark areas. Increase the
contrast to make light areas lighter and dark areas darker. Decrease it to
minimize the difference between light and dark areas.