Filter
Top Products
Skip over perforation
If you turn on this feature, the printer skips over the
perforations of continuous paper, providing a 1-inch margin
between the last line printed on one page and the first line
printed on the next. Because most software programs set their
own top and bottom margins, you should use this feature only
if your program does not provide them. This feature does not
affect single-sheet paper.
Auto tear off
When you use continuous paper with the tractor or banner
paper, this feature advances the paper perforation or end of
printed page to the tear-off position where you can easily tear
off or cut off the printed pages. When the printer receives data,
it automatically feeds the paper to the top-of-form position and
starts printing, so you can use all of the next sheet.
c
Caution:
If you use the tractor feeder to print labels, set this feature to
off. Otherwise labels may come off the backing and jam the
printer.
Banner mode
If you turn on this mode, the banner paper is not recognized as
single-sheet paper even if the paper-release lever is set to the
single-sheet position. Therefore, paper is not ejected and
advanced forward to the next page with the
LF/FF
button.
Parallel I/F transfer rate
This setting specifies the I/F transfer rate. For most printing,
leave this setting set to Fast. If you encounter problems, set it to
Normal.
8
R
Loire2 Ref. Guide
Rev.c
A5 size Chapter 8
11-11-96 DR, pass 0
The Control Panel
8-9