Filter
Top Products
Paper may be jammed in the
paper path.
Turn off the printer and open the
printer cover using the notch on the
cover; then gently pull out the paper
by turning the knob toward you.
Remove any remaining pieces of
paper. See “Clearing a paper jam” on
page 10-23.
A single sheet does not feed properly from the manual feed
slot.
Cause What to do
Paper is curled or folded. Use flat, non-damaged paper.
The paper may be too thick
or too thin to be fed.
See “Technical Specifications” in
Appendix C.
Continuous paper may be left
in the paper path.
Remove the continuous paper.
The paper-release lever is set
to the wrong position.
Make sure that the paper-release lever
is set to the single-sheet position. See
page 3-2 (Windows) or 5-2
(Macintosh).
The single sheet is not loaded
deeply enough.
Load a single sheet into the manual
feed slot until it meets resistance.
10
Troubleshooting
R
Loire2 Ref. Guide
Rev.c
A5 size Chapter 10
11-11-96 DR, pass 0
Troubleshooting
10-17