Filter
Top Products
The banner mode setting is
on.
Make sure the banner mode setting is
off. If this setting is on, the printer
feeds paper a specified length. Change
this setting using the default-setting
mode. See “Using the Default-Setting
Mode” in Chapter 8.
Paper feeding is crooked.
Cause What to do
The edge guide of the sheet
feeder may not match the
paper’s width.
Adjust the edge guides.
There may be too much
paper in the sheet feeder.
Remove some paper.
You are printing on
oversized paper, and the
paper may be obstructed by
the output tray.
Raise the output tray by extending the
legs under both sides of the tray to
keep enough clearance between the
output tray and paper support. See
“Loading oversized paper into the
sheet feeder” in Chapter 7.
Single sheets are not loaded
far enough.
Load a single sheet into the manual
feed slot until it meets resistance.
The paper may be old or
creased.
Use only new, smooth sheets of paper.
Make sure that your paper is
the proper size and quality.
See Appendix C.
10
Troubleshooting
R
Loire2 Ref. Guide
Rev.c
A5 size Chapter 10
11-11-96 DR, pass 0
Troubleshooting
10-19