Filter
Top Products
Start Here
5
Load paper
1 Open the paper support and pull up the extensions.
2 Open the output tray, pull out the extension, and raise the
paper stopper.
3 Pinch the edge guide and slide it to the left.
4 Load paper against the right edge guide and behind the
tab, with the printable side face up.
4 x 6
8½ x 11
Note: Don’t load the paper sideways; always
load it short edge first.
5 Slide the edge guide over.
Read these instructions before using your product.
1
Unpack
USB cable
Power cord
Caution: Do not open the ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
2
Turn on
1 Connect the power cable.
Caution: Do not connect to your computer yet.
2 Press the On button.
3
Make settings
Stop/
Clear Settings
B&W
Color
/
Fax
1 Press or to select your language, then press OK.
2 Press or to select your country or region, then press
OK.
3 Press or to select Summer if your region uses Daylight
Saving Time and it’s currently in effect. (DST is effective from
spring through summer.) Otherwise select Winter to turn off
the setting.
4 Press OK.
5 Press or to select the date format, then press OK.
6 Use the numeric keypad to change the date, then press OK.
7 Press or to select a 12-hour or 24-hour time format,
then press OK.
8 Use the numeric keypad to set the time.
If you chose a 12-hour time format, press or to select
AM or PM.
9 Press OK.
4
Install ink cartridges
1 Lift up the scanner.
2 Open the cartridge cover.
3 Shake the ink cartridges, then unpack them.
4 Remove only the yellow tape from each cartridge.
Caution: Don’t remove any other seals from the cartridges.
5 Insert the cartridges in the holder for each color.
6 Press each cartridge down until it clicks.
7 Close the ink cartridge cover and press it down until
it clicks.
8 Lower the scanner.
9 Press the OK button to charge the ink. Charging takes
about 2 minutes.
Note: Your printer ships with full cartridges and part of the ink
from the first cartridges is used for priming the printer.
Caution: Don’t turn off the printer while it is charging or you’ll
waste ink.
Epson Stylus
®
NX300/305 Series
*411852500*
*411852500*