Filter
Top Products
Epson Perfection V350 Photo
8/06 Epson Perfection V350 Photo - 5
2. Make sure the film strip is placed as shown.
3. Scanning the first 3 frames of the film strip:
Place the film holder on the document table so that it is
aligned as shown. Make sure the tab labelled “B” on the film
holder fits into the area labelled “B” on the scanner.
Scanning the last 3 frames of the film strip:
Remove the film strip from the film holder, then re-insert it
with the last frame first. Place the film holder on the
document table so that it is aligned as shown below.
4. Close the scanner cover.
When you are finished scanning film, be sure to replace the
document mat before scanning documents or photos. See
page 8.
Placing Film in the Auto Film Loader
The Perfection V350 Photo comes with an auto film loader on
the scanner cover that lets you load a film strip for scanning
automatically. Before loading a filmstrip in the auto film loader,
however, make sure it meets these requirements to avoid
damaging your film or the film loader:
❏ The film is dry.
❏ The film is not infrared film.
❏ The film is 35 mm wide and 2.9 to 9.1 inches (74 to
232 mm) long.
❏ The film strip contains at least 2 photos, but no more
than 6.
❏ The film has no damaged edges or holes along the sides.
❏ The film has no folds, ripples, bends, or curls.
❏ The film has no stickers on it. If there is a sticker on the film
strip away from the image, you can carefully cut off the part
with the sticker.
Note: If you want to scan film that does not meet these
requirements, use the film holder, instead. See “Placing Film in the
Holder” on page 4.