Filter
Top Products
LBI-39224
3-98
the selected channel by entering "YES" in the ALC text box or disable
it by entering "NO."
Save and Send CTIM Configurations
When channel configuration of the selected CTIM is complete, the
Site Channel Configuration dialog box changes must be sent to the
CEC/IMC before the changes will take effect. This reprograms the
CTIM Controller Boards. However, it is important to save the new
configuration prior to sending it to the CEC/IMC because a send will
send the last configuration that was saved to disk; saving first ensures
that the actual CEC/IMC channel configuration will be the same as the
channel configuration stored on the CEC/IMC Manager hard disk. To
save and send configurations, action is required first in the
Site Channel Configuration dialog box and then in the
Site Channel Configuration List dialog box.
Site Channel Configuration dialog box
Save
Choose the Save button to perform an immediate save of the currently
selected CTIM channel configuration. Other CTIMs displayed in the
list box located at the top of the dialog box are not saved. This channel
configuration is saved on the CEC/IMC Manager's hard disk drive.
Any previous channel configuration for the CTIM, if present, is erased
and replaced with the current channel configuration. If the CEC/IMC
Manager is running remotely or as a part of the EDACS Network
Manager, this configuration is saved on the CEC/IMC Manager server,
typically local to the CEC/IMC; it is not saved at the remote location.
Save As...
Choose the Save As… button to allow the currently selected CTIM
channel configurations to be saved as a different CTIM. It is provided
to speed configurations when similar channel configurations are
required. Upon choosing Save As… a small dialog box (see Figure 17
on page 3-34) will appear which allows selection of a new CTIM
number. Select the desired CTIM number from one of the choices in
the drop-down list box, the choices listed are the selected CTIMs in the
Configured/Active Sites list box. Like Save, Save As… stores
channel configuration on the CEC/IMC Manager server.