Filter
Top Products
LBI-39224
3-191
System Options dialog box (Configure System /
System Options / Multisite Settings). This does not
reset unit timers or change unit timer reset values, so if
"Multisite Unit Logout" is selected (enabled) the unit
timers will again decrement from the previously set
values.
Command Logout
Command logout instantly logs the requested unit off of all sites.
The command logout option can be selected to mark and logoff
operator selected units when it is not desired to have units
automatically log off the CEC/IMC (timed logout).
Multisite Unit Logout has two modes of operation, Timed Logout and
Command Logout. These two modes are NOT exclusive; if a situation
develops where a unit must be command logged off, this can be done
regardless of the Logout Timer status. A brief description of each
follows.
In order for a call to NOT be routed to a particular group/site,
ALL units must be logged off so that Group Count is equal to
zero.
Timed Logout
A unit's multisite timer is set to a predetermined time each time it
(the radio) keys. Timed logout logs units off of all sites after the
requested unit has not shown any activity (keyed or login to
another site) for the predetermined time. Multisite timers for all
units are set-up via the Unit/Group Locations and Unit Logout
(Multisite Unit Logout in System Options menu) dialog box and
they are maintained by (stored in) the MOM Controller Board.
A unit timer is maintained for each unit, and has the following
characteristics:
– Set at the CEC/IMC Manager and stored in MOM
Controller Board NOVRAM.
– Set from 0 to 24 hours in 15 minute increments.
– Set ALL timers to the same value.
– SEND timers by.
NOTE