Filter
Top Products
LBI-39224
4-7
4.3.1 Licensed Features
Failsoft Patch
This license allows the customer to perform console dispatch patch
operations when the system is in Trunked Failsoft operation. A
CEC/IMC that is connected to an EDACS basic Failsoft site will be in
Trunked Failsoft mode. This feature requires GETC software that
supports Failsoft patch and C3 Maestro software 4.0 or later to operate
correctly. Leaving this feature disabled at the CEC/IMC is an effective
means of preventing Failsoft patch attempts on a system that does not
have Failsoft patch capable software at all sites. Patch attempts will be
denied consistently until all sites are upgraded, then the license can be
installed to enable the feature. This feature is enabled if the check box
is selected.
Landline Data
A customer must have this license in order to install an Ericsson Data
Gateway (EDG) product in the CEC/IMC. This license is not required
for radio to radio RF Data. This feature is enabled if the check box is
selected.
Landline Digital
This license allows a customer to perform MultiSite Aegis or Voice
Guard calls. This feature also requires DVIM/DVIU channels,
StarGate controller, multiple sites capable of digital calls, conventional
interface, and at least two digital capable radios and consoles to
perform Digital Dispatch or Digital Interconnect calls. Single site radio
to radio Aegis or Voice Guard calls do not require a license. This
feature is enabled if the check box is selected.
4.3.2 Licensed Capacities
MSC Type
The CEC/IMC may be ordered in several different base configurations
for different purposes (CEC or IMC for example). This license is used
by the software to determine the current node configuration for
CEC/IMC type specific processing. The license must match the
ordered node type for all features to operate properly. The node type
controller that the CEC/IMC Manager is connected to is indicated by
the following table.