Filter
Top Products
LBI-39224
2-4
1. VERIFY that the MIGRATE.BAT utility has been executed to
save the original (DOS) CEC/IMC Manager configuration.
2. Insert the "Install" CEC/IMC Manager V5.0 for Windows NT
diskette and execute SETUP.EXE. This setup utility will:
– Copy all necessary Executables and DLLs
– Install the CEC/IMC Manager server as a service
– Install the CEC/IMC Manager GUI
– Setup Program Groups and CEC/IMC Manager Icons
– Execute the necessary registry edits
3. (OPTIONAL) Insert the "Install" SNMP Agent Diskette and
execute SETUP.EXE.
4. Insert the "Migrate Utility" diskette and execute
MIGRATE.BAT to transfer the previous (DOS) CEC/IMC
Manager configuration to the just installed (Windows NT)
CEC/IMC Manager. This should be the second time
MIGRATE.BAT was run since the original (DOS) CEC/IMC
Manager configuration was saved using this utility on the
(DOS) CEC/IMC Manager machine. In a DOS Window:
From the C:\WINMOM prompt type a:\migrate TO.
5. Reboot the CEC/IMC Manager PC.
6. Double-click on the CEC/IMC Manager icon (in the
WINMOM program group) to execute the CEC/IMC Manager
GUI.
Expect to see "NOVRAM MISMATCH" Popup windows.
These occur because the DOS MOMPC did not save Bus/Slots
to disk. Although the Migration utility preserved much of the
configuration, the bus/slots at the CEC/IMC Manager will be
zero and the MOM Controller will hold the valid Bus/Slots
configuration. By following steps 7-13 the entire slot database
should be stored to the CEC/IMC Manager V5.0 hard disk.
IMPORTANT NOTE