Filter
Top Products
LBI-39224
B-4
LOGGED
WARNING
MESSAGE
LOGGED
WARNING
DATA
CAUSE/
CORRECTIVE
ACTION
W06-033:
MISMATCH - AUDIO
CHANNEL
Logical ID (LID) of
the unit that
experienced the
missed channel drop.
The CEC/IMC has received a
channel assignment for a unit that
is marked active on another
channel. This is a missed channel
drop condition – the CEC/IMC will
drop the existing channel before
routing the new channel
assignment.
W06-116:
MISMATCH -
ASSIGNMENT
Site number reported
in the Site ID record
from the site.
The MIM assignment from the DIP
switches does not match the site
number reported from the site.
This warning will only be issued
once by the MIM when detected.
W06-119:
MISMATCH -
MULTIPLE END
NODES
(none) A second Controller Board has
responded that is set up to be an
end node. This message is not
generated by MOM Controller
Board firmware version 3.00 (or
later); it is replaced by error
message E07-119.
WO6-134:
MISMATCH -
BACKUP ID
New backup node ID MOM has received a new backup
node ID for a redundant MIM pair
and has overwritten the old backup
ID. This warning may occur when
changing/resetting the primary/
secondary MIMs, and is not a
problem in this case. However, if
this warning occurs at any other
time it indicates the MOM may be
confused about the primary/backup
IDs; backup operation should be
verified (reset primary/secondary
nodes). This situation is most
likely to occur if a third MIM with
the same assignment is mistakenly
installed in the CEC/IMC.
W07-115:
OVERFLOW - PATCH/
SIMULSELECT
The maximum
number of
simultaneous patches
and simulselects
allowed on this
switch.
An attempt was made to create a
patch/simulselect, but the MOM
Controller Board patch/simulselect
table already contains the
maximum number of entries.