Filter
Top Products
146
146 | Solving Problems
CLEANING ERROR
AUTOMATIC HEAD
CLEANING FAILED
RETRY?
YES
NO
Head cleaning did not clear the
nozzles.
Press to clear the error and run the
head cleaning utility again. If cleaning
doesn’t start, cancel printing from the
computer. Then turn the printer off and back
on again.
CLEANING ERROR
NOT ENOUGH INK.
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough ink to
perform cleaning.
Select Yes and replace the cartridge (see
page 126).
CLEANING ERROR
NOT ENOUGH EMPTY
SPACE IN MAINT BOX 1.
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
There is not enough space in
the ink maintenance tank to
perform cleaning.
Select Yes and replace the maintenance
tank (see page 137).
CLOGGED NOZZLES
DETECTED
CLEANING RECOMMENDED
One or more of the ink nozzles
are clogged.
Perform head cleaning to remove any clogs.
This message will display until the clogged
nozzle has been cleared. Printing a check
pattern will clear the message.
COMMAND ERROR
CHECK DRIVER SETTINGS
You may be using the wrong
printer driver.
Damaged data was sent to the
printer or the data has an
incorrect command.
Press to cancel the print job and reset
the printer. Make sure you installed the
correct driver for your printer.
CUTTER UNIT NEARING
END OF SERVICE LIFE.
RECOMMEND REPLACING
THE CUTTER UNIT
The paper cutter may be dull. Replace the paper cutter; see page 133.
F/W INSTALL ERROR
UPDATE FAILED RESTART
THE PRINTER
Firmware update failed. Restart the printer, then update the
firmware again; see page 35.
INK CARTRIDGE ALERT
REPLACE INK
CARTRIDGE(S)
The ink cartridge is expended. Replace the ink cartridge; see page 126.
Message Explanation Response