Filter
Top Products
PMK 155 • Installation Guide
The Extron
®
PMK 155 Pole Mount Kit is a simple solution for mounting Extron devices and
their external power supplies to a projector pole. The PMK can be installed on a 1.5-inch
pipe within a 4-inch space between the projector and the ceiling.
Including the power supply, the following devices can be mounted:
z one three-inch deep half-rack device, or
z one six-inch deep half-rack device, or
z two three-inch deep quarter rack devices,
or
z an MPA 401
ATTENTION: The maximum load for the
PMK 155 is 5 lbs (2.25 kg).
NOTE: The PMK 155 is to be used only
with Extron UL listed products.
Installation
NOTE: Ensure the finished installation is in accordance with local and national buildng
codes, fire and safety codes, UL requirements, and local and national electrical
codes.
To install the PMK 155 (with a device) on a projector pole:
1. Place the plate on the base of the device and align holes in the plate with the
mounting holes in the device.
(2) 4-40 x 3/16"
Screws
Use 2 mounting holes on
opposite corners.
2. Secure the device to the plate with 4-40 screws.
ATTENTION: Use only the screws supplied with the device to avoid damaging it.
Pipe Clamp
Mounting Plate
(2) Tie Wraps
(2) Hex Bolts
(2) Washers