Extron electronic PMK 550 Projector Accessories User Manual


 
IMPORTANT:
Go to www.extron.com for the
complete system installation guide,
instructions, and specifications.
PMK 550 • Installation Guide
The Extron PMK 550 Pole Mount Kit, designed for use with the Extron PoleVault
System, allows for easy mounting of PoleVault
products to a projector pole. The PMK 550 is compatible with both the PVS 204 series and PVS 305 series of PoleVault switchers.
When installed it mounts the PoleVault system switcher, the associated power supply, and an accessory device within an
enclosure below a suspended ceiling.
CAUTION: Maximum load for the PMK 550 is 15 lbs (6.8 kg).
Items included in the kit are:
Covers (2), Base plate (1), Mounting plate (1),
Tie wraps and pads (to secure power supply),
4-40 Screws (to mount devices) (3), Cover Screws, (4)
NOTE: For full device installation, configuration,
menus, connector wiring, and operation
details of the PoleVault switcher, see the
relevant PoleVault System Installation Guide
available at www.extron.com.
Installation
To install the PMK 550 in a PoleVault system:
1. Remove the four cover screws from the center (see gure 1).
Slide the two halves apart and remove them from the base plate.
NOTE: If the PoleVault switcher and its power supply are
already installed, go directly to step 5.
2. To mount the PoleVault switcher, place the mounting plate, with the
raised tabs upwards, on top of the switcher top and pass the two
supplied 4-40 x 3/16 inch screws into the top of the switcher (see
gure 2, top). Secure the mounting plate but do not overtighten.
3. Hook the combined plate and switcher into the PMK 550 base plate.
Secure it to the base plate with two screws.
NOTES:
Any installed switcher should be secured to the plate
in an upside down position so that when the plate is
rotated to hang from the ceiling, the device will be in
its correct orientation (see gure 2, bottom).
Use only supplied screws to avoid damaging the
switcher.
4. Attach the associated power supply with the supplied tie wraps and
pads, by passing them through the appropriate slots and around the
power supply (see gures 2 and 3). Tighten until snug.
SIGNAL
5
AUX AUDIO
SENSOR
SENSITIVITY
5
AUX AUDIO
PMK Covers (2)
Base Plate
To open, remove 4 cover screws
and slide the covers away.
Mounting Plate (1)
Figure 1. PMK 550
Figure 2. Installing the PVS Switcher
PVS 305SA IP
POLEVAULT SWITCHER
INPUT SELECTION
1
2
PEAK
NORMAL
SIGNAL
CONFIG
3 4
5
AUX AUDIO
AUDIO LEVEL ADJUST
PAGING
SENSOR
SENSITIVITY
VOICELIFT
MIC
PEAK
NORMAL
SIGNAL
INPUT