Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
145
Attaching the Card Lamination Module
The Card Lamination Module can be attached to select Printer models (DTC525 only) as a
field upgradeable option. This can typically be done in 20 minutes or less and with no other
tools than a phillips screw driver. Please refer to the following steps to attach this module.
This section applies only if you are installing the field upgradeable Card Lamination Module
onto a Printer. Your Printer model must be capable of accepting this module as not all Printer
models are compatible with this field upgradeable option. If you have questions about
compatibility, please contact your authorized Fargo reseller.
Step Procedure
1 Remove the Card Lamination Module from its packaging.
2 Disconnect the power cable from the Printer.
3
Remove the Card Output Hopper from the Printer. (Note: To do this, pull out
on the Securing Tab located on the bottom of the Printer and slide the Card
Output Hopper completely out of the Printer.)
Continued on the next page
Securing Tab