Filter
Top Products
RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
150
Attaching the Card Lamination Module (continued)
Step Procedure
10 While being careful not to scratch the plastic cover, remove the Fargo DTC525
model number label from the front of the Printer and replace it with the
included Fargo DTC525-LC model number label. (Note: This is important so
users know the exact Printer model when ordering supplies, when calling for
technical assistance or when downloading Printer Driver/Firmware Updates.)
11 If you have not already done so, install the LC version of your Printer model's
Printer Drive.
For lamination-related Printer Driver options, see the Using the Lamination
tab (only with Card Lamination Module) in Section 4, page 228.
For overlaminate information, see the Reviewing the Overlaminates in
Section 1, page 61 and Loading the Overlaminate in Section 3, page 134.
The packaging for the Card Lamination Module has been designed to
accommodate shipping either the lamination module-only or the fully
assembled Printer with lamination module.
After assembling the complete Printer/lamination system, please re-use the
lamination module packaging when transporting the unit.
12 Once all print supplies are installed, run a test print to make sure installation
was successful.
You must have PolyGuard™ overlaminate and a full-color print Ribbon
installed to print this test image.
To test, go to the Printer’s LCD display and select MENU, PRINT TEST
IMAGE and run the lamination Self Test named: Color/Resin YMCK+L.
The test image will begin printing after a few seconds and will both print
and laminate the card.