Filter
Top Products
45
Users Manual
1-2
• 100,000, 30,000, and 3,000 selectable count resolution, with display reading speeds
of 2.5, 5, and 20 readings per second (rps), respectively.
• Built-in self-tests with closed-case calibration (no internal calibration adjustments).
Options and Accessories
Two options are available. These options can be installed in the meter at the factory or by
the customer on site:
• The IEEE-488 Interface (Option -O5K) provides full programmability, and
automated calibration. The IEEE-488 computer interface command set is identical to
the RS-232 interface commands wherever possible.
• The Battery Kit (Option -01 K) consists of a rechargeable, 8 V, lead-acid battery,
with battery bracket and charger assembly. The battery has a typical operating time
of eight hours and is fully operable at ambient temperatures between 0 and 50 °C. For
complete battery specifications, refer to Appendix A.
Available accessories are listed and described in Table 1-1.
Table 1-1. Accessories
Model Description
C40 Soft carrying case. Provides padded protection for the meter. Includes a pocket for the
manual and pouch for the test leads and line cord.
M00-200-634 Rackmount Kit. Allows meter to be mounted on either the right or left side of a standard
19-inch rack.
RS40 RS-232 terminal interface cable. Connects the Fluke 45 to any terminal or printer with
properly configured DTE connector (DB-25 socket), including an IBM PC
®
, IBM PC/XT
®
or IBM PS/2 (models 25, 30, 5O, P60, 70, and 80).
RS41 RS-232 modem cable. Connects the Fluke 45 to a modem with properly configured DB-25
male pin connector.
S45 QuickStart ™, a PC software package, simplifies operation of the Fluke 45 when using the
RS-232 computer interface. Readings are recorded in files that can be accessed by Lotus
1-2-3
®
, dBase lll
®
and other graphics packages.
Y8021 Shielded IEEE-488 one-meter (39.4 inches) cable, with plug and jack at each end.
Y8022 Shielded IEEE-488 two-meter (78.8 inches) cable, with plug and jack at each end.
Y8023 Shielded IEEE-488 four-meter (13 feet) cable, with plug and jack at each end.
Where to go from Here
This manual has been organized to assist you in getting started quickly. It is not necessary
for you to read the entire manual before using the meter effectively. However, we recom-
mend that you do so in order to use your meter to its full advantage.
Begin by scanning the Table of Contents to familiarize yourself with the organization of
the manual. Then, read Chapter 2, "GETTING STARTED". Refer to the appropriate
chapter of the manual as needed. The contents of each chapter are summarized below.
Chapter 1: Introduction
Introduces the Fluke 45 Dual Display Multimeter, describing its features, options, acces-
sories, and users manual.