Filter
Top Products
- 147 -
<0 - 7> - Priority Id from 0 to 7.
lan - Sets ETS Priority Id to LAN priority group
san - Sets ETS Priority Id to SAN priority group
ipc - Sets ETS Priority Id to IPC priority group
no - This command restores the priority to priority group mapping list to default value.
Default Setting
Priority id 0 to 2 in LAN, 3 to 6 in SAN and 7 in IPC
Command Mode
Interface Config
7.2.18 Congestion Notification
7.2.18.1 show congestion-notify
This command displays CN function global parameter on system.
Syntax
show congestion-notify
Default Setting
None
Command Mode
Privileged Exec
Display Message
Congestion Notify: Displays Congestion Notification function status.
Tag ethertype recognize: When set to 1 , CN-Tag ether type is recognized by parsing stages
Tag ethertype: A new tag that is being added by 802.1Qau as a part of the congestion management
requirements.
Msg ethertype: A message generated by the CP which informs the reaction point(RP) about the
level of congestion at the CP.
CPID devid: Congestion point ID, A 64 bit value associated with every CP in the network. It is sent
back along with every CNM so that network adminiatrators can use the CNMs to debug their network.
CPID LSB:. Displays Control the LSB field of Congestion Point Identifier of CNM payload.
outer TPID:. Displays Outer TPID for Congestion Notification Message (CNM).
outer VLAN: Displays Outer VLAN ID for Congestion Notification Message (CNM).
outer Dot1p: Displays Outer Packet Priority for Congestion Notification Message