Filter
Top Products
- 171 -
Syntax
show trapflags
Default Setting
None
Command Mode
Privileged Exec
Display Message
Authentication Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
authentication failure traps will be sent.
Link Up/Down Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
link status traps will be sent.
Multiple Users Flag: May be enabled or disabled. The factory default is enabled. Indicates whether a
trap will be sent when the same user ID is logged into the switch more than once at the same time
(either via telnet or serial port).
Spanning Tree Flag: May be enabled or disabled. The factory default is enabled. Indicates whether
spanning tree traps will be sent.
DVMRP Traps May be enabled or disabled. The factory default is disabled. Indicates whether
DVMRP traps will be sent.
OSPFv2 Traps May be enabled or disabled. The factory default is disabled. Indicates whether
OSPF traps will be sent.
OSPFv3 Traps May be enabled or disabled. The factory default is disabled. Indicates whether OSPF
traps will be sent.
PIM Traps May be enabled or disabled. The factory default is disabled. Indicates whether PIM traps
will be sent.
7.3.5.3 snmp-server sysname
This command sets the name of the switch. The range for name is from 1 to 31 alphanumeric characters.
Syntax
snmp-server sysname <name>
<name> - Range is from 1 to 31 alphanumeric characters.
Default Setting
None
Command Mode