Filter
Top Products
- 175 -
range of IP addresses from which SNMP clients may use that community to access the device. A value of
0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with the mask to determine
the range of allowed client IP addresses. The name is the applicable community name.
Syntax
snmp-server community ipaddr <ipaddr> <name>
no snmp-server community ipaddr <name>
<name> - community name.
<ipaddr> - a client IP address.
no - This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Default Setting
0.0.0.0
Command Mode
Global Config
7.3.5.8 snmp-server enable traps
This command enables the acl trap.
Syntax
snmp-server enable traps acl-trapflags
no snmp-server enable traps acl-trapflags
no - This command disables the acl trap.
Default Setting
Enabled
Command Mode
Global Config
This command enables the Authentication trap.
Syntax
snmp-server enable traps authentication
no snmp-server enable traps authentication