Filter
Top Products
- 294 -
no lldp notification
no - This command is used to disable notifications.
Default Setting
Disbaled
Command Mode
Interface Config
7.12.2.2 lldp notification-interval
This command is used to configure how frequently the system sends remote data change notifications.
The <interval-seconds> parameter is the number of seconds to wait between sending notifications. The
valid interval range is 5-3600 seconds.
Syntax
lldp notification-interval <interval-seconds>
no lldp notification-interval
<interval-seconds> - Configures the number of seconds to wait between sending notifications.
no - This command is used to return the notification interval to the default value.
Default Setting
5
Command Mode
Global Config
7.12.2.3 lldp receive
This command uses to enable the LLDP receive capability.
Syntax
lldp receive
no lldp receive
no - This command is used to return the reception of LLDPDUs to the default value.