Filter
Top Products
- 317 -
None
Command Mode
Privileged Exec
Display Message
Name: An name of the protected port group.
Protected: Indicates whether the interface is protected or not. It shows TRUE or FALSE. If the group
is a multiple groups then it shows TRUE in Group <groupid>.
7.15.2 Configuration Commands
7.15.2.1 switchport protected
This command used to modify a protected port group name. The <groupid> parameter identifies the set of
protected ports. Use the name <name> pair to assign a name to the protected port group. The name can
be up to 32 alphanumeric characters long, including blanks. The default is blank.
!
Port protection occurs within a single switch. Protected port configuration does not affect
traffic between ports on two different switches. No traffic forwarding is possible between
two protected ports.
Syntax
switchport protected <0-2> name <name>
no switchport protected <0-2> name
<name> - Assigns a name to the protected port group.
no - Remove a name from the protected port group.
Default Setting
None
Command Mode
Global Config
This command uses to add an interface to a protected port group. The <groupid> parameter
identifies the set of protected ports to which this interface is assigned. You can only configure
an interface as protected in one group.
Syntax