Filter
Top Products
- 338 -
<maxTtl> - Use maxTtle to specify the maximum TTL. Range is 1 to 255.
<interval> - Use interval to specify the time between probes, in seconds. Range is 1 to 60 seconds.
<count> - Use the optional count parameter to specify the number of probes to send for each TTL
value. Range is 1 to 10 probes.
Default Setting
None
Command Mode
Previledge Mode
7.17.8.2 traceroute ipv6
This command is used to discover the routes that packets actually take when traveling to their destination
through the network on a hop-by-hop basis. The <ipv6-address|hostname> parameter must be a valid
IPv6 address|hostname.
Syntax
traceroute ipv6 <ipv6-address|hostname > [initTtl <initTtl>] [maxTtl <maxTtl>] [interval <interval>]
[count <count>]
<ipv6-address|hostname> - A valid IPv6 address or hostname.
<ipaddr> - The IP address or destination host you want to trace.
<initTtl> - The Use initTtl to specify the initial time-to-live (TTL), the maximum number of router hops
between the local and remote system. Range is 1 to 255.
<maxTtl> - Use maxTtle to specify the maximum TTL. Range is 1 to 255.
<interval> - Use interval to specify the time between probes, in seconds. Range is 1 to 60 seconds.
<count> - Use the optional count parameter to specify the number of probes to send for each TTL
value. Range is 1 to 10 probes.
Default Setting
None
Command Mode
Privileged Exec
7.17.9 logging cli-command
This command enables the CLI command Logging feature. The Command Logging component enables
the switch to log all Command Line Interface (CLI) commands issued on the system.