Filter
Top Products
- 399 -
Default Setting
None
Command Mode
Global Config
7.23.2.2 ipv6 access-list rename
This command changes the name of an IPv6 ACL. The <name> parameter is the name of an existing
IPv6 ACL. The <newname> parameter is a case-sensitive alphanumeric string from 1 to 31 characters
uniquely identifying the IPv6 access list.
This command fails is an IPv6 ACL by the name <newname> already exists.
Syntax
ipv6 access-list rename <oldname> <newname>
<oldname> - current Access Control List name.
<newname> - new Access Control List name.
Default Setting
None
Command Mode
Global Config
7.23.2.3 {deny | permit} (IPv6)
This command creates a new rule for the current IPv6 access list. Each rule is appended to the list of
configured rules for the list.
!
The ‘no’ form of this command is not supported, since the rules within an IPv6 ACL cannot
be deleted individually. Rather, the entire IPv6 ACL must be deleted and respecified.
An implicit ‘deny all’ IPv6 rule always terminates the access list.
A rule may either deny or permit traffic according to the specified classification fields. At a minimum, either
the ‘every’ keyword or the protocol, source address, and destination address values must be specified.
The source and destination IPv6 address fields may be specified using the keyword ‘any’ to indicate a
match on any value in that field. The remaining command parameters are all optional, but the most
frequently used parameters appear in the same relative order as shown in the command format.