Filter
Top Products
- 423 -
None
Command Mode
Privileged Exec
Display Message
Route Codes: Displays the key for the routing protocol codes that might appear in the routing table
output.
The command displays the routing tables in the following format:
Code IP-Address/Mask [Preference/Metric] via Next-Hop, Interface
Code: The codes for the routing protocols that created the routes.
IP-Address/Mask: The IP-Address and mask of the destination network corresponding to this route.
Preference: The administrative distance associated with this route. Routes with low values are
preferred over routes with higher values.
Metric: The cost associated with this route.
via Next-Hop: The outgoing router IP address to use when forwarding traffic to the next router (if any)
in the path toward the destination
Interface: The outgoing router interface to use when forwarding traffic to the next destination
8.2.1.5 show ip route bestroutes
This command displays router route table information for the best routes.
Syntax
show ip route bestroutes
Default Setting
None
Command Mode
Privileged Exec
Display Message
Total Number of Routes: The total number of routes.
Network Address: Is an IP route prefix for the destination.
Subnet Mask: Is a mask of the network and host portion of the IP address for the router interface.
Protocol: Tells which protocol added the specified route. The possibilities are: local, static, OSPF, or
RIP.
for each next hop
Next Hop Intf: The outgoing router interface to use when forwarding traffic to the next destination.