Filter
Top Products
- 473 -
Authentication Key: 16 alpha-numeric characters for authentication key when uses simple or
encrypt authentication.
Authentication Key ID: It is a Key ID when uses MD5 encryption for RIP authentication.
Default Metric: A number which represents the metric used for default routes in RIP updates
originated on the specified interface. This is a configured value. The following information will be
invalid if the link state is down.
Bad Packets Received: The number of RIP response packets received by the RIP process which
were subsequently discarded for any reason.
Bad Routes Received: The number of routes contained in valid RIP packets that were ignored for
any reason.
Updates Sent: The number of triggered RIP updates actually sent on this interface.
8.5.1.3 show ip rip interface brief
This command displays general information for each RIP interface. For this command to display
successful results routing must be enabled per interface (i.e. ip rip).
Syntax
show ip rip interface brief
Default Setting
None
Command Mode
Privileged Exec
Display Message
Interfacet: Valid slot and port number separated by forward slashes.
IP Address: The IP source address used by the specified RIP interface.
Send Version: The RIP version(s) used when sending updates on the specified interface. The types
are none, RIP-1, RIP-1c, RIP-2.
Receive Version: The RIP version(s) allowed when receiving updates from the specified interface.
The types are none, RIP-1, RIP-2, Both
RIP Mode: RIP administrative mode of router RIP operation; enable, disable it.
Link State: The mode of the interface (up or down).
8.5.2 Configuration Commands
8.5.2.1 enable rip
This command resets the default administrative mode of RIP in the router (active).